20
Selecting the delayed start
●
Select the programme and the required
options.
●
Select the delay start you want.
●
Press the button
: the machine starts its
hourly countdown.
The programme will start after the selected
delay has expired.
Cancelling the delayed start
You can cancel the delay time at any moment,
before you press the button
. If you have
already pressed it, and you wish to cancel the
delay time, proceed as follows:
• set the washing machine to PAUSE by
pressing the button
;
• press the buttons
once until the symbol
«
0’
» is displayed.
• press the button
again to start the
programme.
IMPORTANT!
The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing the button
, wait until the pilot light
goes off. After you have closed the door,
press the button
again.
Note!
The Delay Start cannot be selected with
Drain programme.
Altering an option or a running programme
It is possible to change some options before
the programme carries it out.
Before you make any change, you must pause
the washer-dryer by pressing the button
.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «
Off
» and then to the new
programme position. Start the new programme
by depressing the button
again. The
8
8
8
9
8
8
10
8
8
8
washing water in the tub will not be emptied
out.
Interrupting a programme
Press the button
to interrupt a programme
which is running, the corresponding light starts
to flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «
Off
» to cancel a
programme which is running. You can now
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button
. If the light
goes off, the door
can be opened. If it remains on, this means
that the machine is already heating or that the
water level is too high. In this case the door
can not be opened. In any case do not force
the door if it is locked!
If you cannot open the door but you need to
open it, you have to switch the machine off by
turning the selector dial to «
Off
». After about a
few minutes the door can be opened (
pay
attention to the water level and
temperature!
).
After this procedure, it will be necessary to set
the programme and the options again and then
to press the button
.
At the end of the programme
The machine stops automatically. On the
display will appear three flashing zeros
«
0.00
». The door can be opened.
If, at the end of a programme, there is water in
the tub, the door remains locked to indicate
that the water must be emptied out before
opening the door.
To empty out the water:
1. turn the programme selector dial to «
Off
»
2. select the
Drain
or
Spin
programme
8
9
8
8
132963651.qxd 29/05/2008 14.56 Pagina 20
