9
10 “Start/Pause” button
This button has three functions:
•
Start
: after you have selected the desired programme
and options, press this button to start the machine. The
light above the button will stop flashing and remain lit.
If you have selected a delay time by means of button
12, the countdown will begin and will be shown on
the display.
•
Pause
: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
Important!
You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
•
Draining of water and spinning
after the execution
of programmes with the “Rinse Hold” option.
11 “Skip/Reset” button
This button performs two functions:
- Clears the memory
- Selects special programmes
At the end of every programme the “Reset” button must
be pressed once or repeatedly to clear the programme
memory. This will be confirmed by three dashes,
flashing in the display.
If the previous programme is not cleared, the display
will show a “
0
” flashing and an audible signal will
sound, when you switch the machine on.
Selecting a special programme:
A wash programme must be selected in the normal way.
(“Start/Pause” button not pressed)
A normal wash cycle consists of the following phases,
Wash - Rinses - Spin
and is confirmed by the
illumination of the corresponding LED,s.
Start/Pause
To select
rinse & spin
, press the “Skip” button once,
the
wash
LED goes out.
To select
spin
only, press the
“Skip”
button twice.
The
wash
&
rinse
LED,s go out.
To select
Drain
press the
“Skip”
button three times, the
wash - rinse - spin
LED,s go out.
If you wish to cancel or advance the running
programme to the required phase, PAUSE the cycle and
then press the
“Skip”
button as previously described.
Prewash
Wash
Spin
Rinses
Drain
Drying
Prewash
Wash
Spin
Rinses
Drain
Drying
Prewash
Wash
Spin
Rinses
Drain
Drying
Prewash
Wash
Spin
Rinses
Drain
Drying
