34
INSTALLATION
If this appliance – equipped with magnetic door
seals – replaces an older appliance featuring a
spring lock (mechanical latch) on the door or lid,
please ensure that this lock is made completely
unusable before «throwing out» the old appliance.
This will prevent it from becoming a death-trap for
a child.
Location
Place the appliance as far away as possible from
sources of heat, e.g. radiators, heaters, direct
sunlight, etc. The best results are achieved with a
room temperature of b16
°
C and +32
°
C.
Make sure that there is nothing hindering air
circulation at the back, bottom or top of the
appliance. To achieve the best performance, the top
of the appliance – if set under a wall cabinet – should
be at least 50 mm away from the base of the cabinet
(Figure 1 - A). However, the appliance should
ideally not be installed underneath wall cabinets (as
shown in Figure 1 - B).
One or more adjustable feet mounted on the base of
the appliance make it possible to set it perfectly
level.
Fig. 1
Rear spacers
In the plastic envelope containing the Operating
Instructions two wall spacers are also included
which should be fitted into the special openings
provided on the back of the appliance.
Push-fit the spacers into the openings, making sure
that arrow (A) is positioned as per Fig. 2 and then
turn the spacers through 45
°
until they lock in
(arrow in vertical position).
50 mm
A
B
D425
Fig. 2
Power connection
Before plugging in the appliance to the mains
socket, check that the voltage and frequency
indicated on the appliance’s rating plate are the
same as those provided by your home power supply.
A 6% fluctuation above or below rated voltage is
acceptable. For operation using different voltages,
you should use an autotransformer of suitable
capacity.
The appliance MUST be connected to an efficient earth or
ground tap.
The supply-lead plug in fact incorporates a special
earth or ground contact for this purpose.
If by any chance the sockets of your domestic
wiring system are not earthed, the appliance must
be connected to a separate earth or ground wire by
a qualified electrician, in accordance with existing
safety regulations.
The manufacturer declines to accept any liability if this
accident-prevention procedure is not followed.
This appliance complies with E.E.C. directive
number 87/308 of 2.6.87 relative to radio
interference suppression.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the appliance’s interior
Before using the appliance for the first time, wash
all internal parts with lukewarm water and neutral
soap so as to remove the typical «new» smell and
then dry thoroughly. Do not use detergents or
abrasive powders as these will damage the finish.
D060
A
45°
