Zanussi 8181497-00/2
&OHDQLQJ
Clean the cabinet at regular intervals.
Do nt use detergents, abrasive powers,
high perfumed cleaning products, wax
polishes or cleaning products
containing bleach or alcohol when
cleaning the product
,QWHUQDO &OHDQLQJ
Clean the inside and accossories with warm wather
and bicarbonate of soda (5ml to 0,5 liter water) Rise
and dry thoroughly.
Regularly check the door seals and wipe clean to
ensur they are clean and free from debris.
([WHUQDO &OHDQLQJ
Wash the outer cabinet with warm sopy water.
Remove the ventilation grille (see the section
”Removing the ventilation grille”) and
vacuum-clean under the cabinet. Twice a year pull
out the cabinet from the wall and vacuum-clean the
backside of the cabinet, the refrigerating system and
the compressor.
When moving the cabinet, lift it by
the front edge to avoid scratching the
floor.
7R &KDQJH WKH /LJKW %XOE
The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
To replace the lamp in the chiller compartment (only
cabinets with two doors), first unscrew the lamp
grille with a screwdriver.
Use a bulb of the same type, E14 socket, maximum
rating of 25 W.
6RPHWKLQJ 1RW :RUNLQJ
*%
%HIRUH
contacting your local Service Force Center check the following point:
3UREOHP
3RVVLEOH FDXVH 5HPHG\
,W LV WRR ZDUP LQVLGH WKH IUHH]HU
Set a lower temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
,W LV WRR FROG LQVLGH WKH IUHH]HU
Set a higher temperature.
Action Freeze could have been switched on.
7RR PXFK IURVW DQG LFH DUH SURGXFHG
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Set a higher temperature.