Cleaning and maintenance
Cleaning lint filters
To ensure that the appliance works perfectly,
the lint filters in the door and in front of the drum
must be cleaned after every drying cycle.
Caution!
Important. Never operate the
dryer without the lint filter or with a
damaged or blocked lint filter.
1. Open loading door
2. After a period of
time, a patina due to
detergent residue on
laundry forms on the
filters. Then clean the
filters with warm wa-
ter using a brush. Re-
move the filter from
the door pulling it out.
3. Use a damp hand
to clean the micro-
fine filter, which is
built into the lower
part of the loading
aperture.
4. Remove fluff from
lint filter, preferably
using a damp hand
for this purpose.
Replace the filter.
Cleaning heat exchanger
Clean the condenser when light
Condensor
(Condenser)
comes on.
The condenser is situated at the lower part of
the cabinet behind a small door.
1. To open the door,
push the catch as per
picture. During the
drying cycle or at the
end, it is normal for
water to be present
on the surface of the
condenser insertion.
2. Turn the two red
stops downwards.
3. Pull out the con-
denser unit holding it
at the handle .
4. Clean it with a
brush and rinse it un-
der the shower if nec-
essary. Also clean the
outside, removing all
fluff. Clean the rubber
seal round the con-
denser cabinet and in
the inner part of the
small door with a
damp cloth.
Important!
Do not use pointed objects or uten-
sils to clean the spaces between the plates, as
this could damage the condenser and make it
permeable. Re-fit the condenser, turn the red
stops upwards and close the door.
Important!
Do not use this appliance if the
condenser has not been fitted.
27
www.zanussi.com
Summary of Contents for ZTEB 288
Page 63: ...63 www zanussi com ...