28
Operating sequence
Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door.
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Select the drying programme or time. The lights
, and come
on.
6. If required, press the low temperature button
and/or the buzzer OFF button
or the
QUICK drying button
.
7. Press the Start button
: the corresponding
light stops flashing and drying starts. Only the
light remains
lit.
If the programme selector dial is turned to
another position, when the machine is running,
the buzzer will sound and the indicator lights will
flash.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (light
is on).
You may remove the laundry after this phase.
The lights
,
and
illuminate.
8. If the laundry is not removed at the end of the
cycle, the dryer performs an
anti-creasing
phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
Lights
,
and
remain lit and the buzzer
sounds for 2 minutes.
P1108
P1149
9. Turn the programme selector dial to “
0
”; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the selector dial to “0” all the indicator
lights come on.
After each use
• Clean the filters (see page 30).
• Empty the water reservoir (see page 31).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position
and wait
until the end of this cooling phase before removing
the laundry. This will avoid a build-up of heat inside
the appliance.To do this first turn the dial to “
0
” and
then to
and depress Start button
.
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
“
0
”. Select the new programme and press the Start
button .
125983101.qxp 2006-03-13 13:13 Page 28
