ENGLISH
9
Operating sequence
Before using your tumble dryer for the first time, we
recommend to place a few damp cloths inside the
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door.
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does
not get caught between the door and filter.
5. Press the ON/OFF button
: the mains-ON light
comes on.
6. Select the drying programme or time.
7. If required, press the low temperature button
and/or the buzzer OFF button
.
8. Press the Start button
for 2 seconds: light
comes on and drying starts.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (light
is on).
You may remove the laundry after this phase.
9. If the laundry is not removed at the end of the
cycle, the dryer performs an
anti-creasing
phase
(duration: 30 minutes maximum).
The buzzer sounds every 10 seconds (if the
button has not been pressed).
Lights and flash
alternately.
If you do not remove the laundry, the dryer will
stop automatically at the end of the anti-creasing
phase.
P1108
P11
49
Lights
and
flash and the mains-ON light
stays on.
Turn the programme selector dial to “
0
”; lights
and go
out.
Release the ON/OFF button (the mains-ON light
goes out) and immediately remove the laundry.
After each use
• Turn the programme selector dial to “
0
”.
• Switch the appliance off by releasing the ON/OFF
button
. The mains-ON light goes out.
• Clean the filters (see page 11).
• Empty the water reservoir (see page 12).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
programme selector dial to position
(cooling) and
wait until the end of this phase before removing the
laundry. This will avoid a build-up of heat inside the
appliance.To do this first turn the dial to “
0
” and then
to
and depress Start button
.
Modifying the programme
To change a programme which is running, first
cancel it by turning the programme selector dial to
“
0
”. Select the new programme and press the Start
button .
125980903.qxp 2006-04-19 10:56 Page 9
