Problem
Possible cause
Remedy
Fluff filter clogged.
Clean fluff filter.
Overloading of laundry.
Observe recommended loading
volumes.
Ventilation slots covered up.
Uncover ventilation slots.
Residue on inside surface of drum
or drum ribs.
Clean inside surface of drum and
drum ribs.
Conductance of water at installa-
tion site differs from standard set-
ting of machine.
1)
Re-programme standard setting
for degree of drying (see ‘Machine
settings’ chapter)
1)
.
Loading door does not close.
Filter not in place
2)
.
Install filter into place
2)
.
Drying cycle ends shortly after pro-
gramme starts.
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Select time programme or higher
drying level (e.g. EXTRA DROOG
(EXTRA DRY) instead of KAST-
DROOG (STORAGE DRY) ).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends auto-
matically.
Filter clogged.
Clean filter.
Load volume too big.
Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately spun.
Particularly high room temperature.
Temporary switching off of the
compressor to avoid overload.
Automatic process, there is no
fault with the appliance. If possible,
lower the room temperature.
1)
Only dryers with conductance programming
2)
Only dryers with removable filter
Machine settings
Setting
Implementation
Buzzer permanent off
1.
Turn the programme selector to any programme.
2.
Press simultaneously the
LAGE TEMP. (DELICATE )
and
ANTI-
KREUK / EINDE (LONG ANTICREASE )
buttons and hold down
for approx. 5 seconds.
3.
The buzzer is by default always off.
43
www.zanussi.com
Downloaded from www.vandenborre.be
