WHAT TO DO IF...
Problem
Possible cause
Solution
The appliance is noisy.
The appliance is not suppor-
ted properly.
Check if the appliance stands
stable.
The lamp does not work.
The lamp is in stand-by.
Close and open the door.
The lamp does not work.
The lamp is defective.
Contact the nearest Authorised
Service Centre.
The compressor operates
continually.
Temperature is set incorrect-
ly.
Refer to "Operation" chapter.
Many food products were put
in at the same time.
Wait some hours and then check
the temperature again.
The room temperature is too
high.
Refer to climate class chart on
the rating plate.
Food products placed in the
appliance were too warm.
Allow food products to cool to
room temperature before storing.
The QuickFreeze function is
switched on.
Refer to "QuickFreeze function".
The compressor does not
start immediately after press-
ing the QuickFreeze, or after
changing the temperature.
This is normal, no error has
occurred.
The compressor starts after a pe-
riod of time.
Water flows inside the refrig-
erator.
The water outlet is clogged.
Clean the water outlet.
Food products prevent that
water flows into the water
collector.
Make sure that food products do
not touch the rear plate.
Water flows on the floor.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water outlet to
the evaporative tray.
Temperature cannot be set.
The QuickFreeze or Quick-
Chill function is switched on.
Switch off QuickFreeze or
QuickChill manually, or wait until
the function resets automatically
to set the temperature. Refer to
"QuickFreeze or QuickChill func-
tion".
The temperature in the appli-
ance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower temperature.
The food products' tempera-
ture is too high.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Many food products are stor-
ed at the same time.
Store less food products at the
same time.
7
