Problem
Possible cause
Solution
Temperature is set incorrectly.
Refer to "Operation" chapter.
Water flows on the rear plate of
the refrigerator.
During the automatic defrost-
ing process, frost melts on the
rear plate.
This is correct.
Water flows inside the refrigera-
tor.
The water outlet is clogged.
Clean the water outlet.
Food products prevent that
water flows into the water col-
lector.
Make sure that food products do
not touch the rear plate.
Water flows on the floor.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
Attach the melting water outlet to
the evaporative tray.
The temperature in the appliance
is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower temperature.
The door is not closed correct-
ly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products temperature
decrease to room temperature be-
fore storage.
Many food products are stored
at the same time.
Store less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened of-
ten.
Open the door only if necessary.
There is no cold air circulation
in the appliance.
Make sure that there is cold air cir-
culation in the appliance.
If the advice does not lead to the
desired result, call the nearest
brand-mark service.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
Replacing the lamp
The appliance is equipped with a
longlife LED interior light.
CAUTION!
Disconnect the plug from the mains
socket.
1. At the same time, with the fingers expand
up and down the transparent cover and
unhook it in the direction of the arrows.
www.zanussi.com
23