20
EN
For further technical information please refer to
the rating on the internal left side of the appli-
ance and in the energy label.
Dimensions
Height
1440mm
Width
554mm
Depth
570mm
Technical Data
Installation
Read the Safety information carefully for
your safety and correct operation of the
appliance before installation.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the climate
class indicated on the rating plate of the appli-
ance:
Climate Class
Ambient
Temperature
SN
+10°C to +32°C
N
+16°C to +32°C
ST
+16°C to +38°C
T
+16°C to +43°C
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be as least 100 mm. Ideally, however, the
appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured
by one or more adjustable feet at the base of the
cabinet.
Warning!
It must be possible to discon-
nect the appliance from the mains power
supply; the plug must therefore be easily
accessible after installation
Caution!
Before replacing the lamp, disconnect the
appliance from mains power supply.
Lamp specification: 220-240 V, max. 1,5 W
Follow below process to replace the lamp:
1.
Set the temperature regulation knob at num-
ber “0” to switch off the appliance.
2.
Unplug the appliance to ensure it is discon-
nected from main power supply.
3.
Remove the screw of the lamp cover.
4.
Pull the lamp cover out.
5.
According to the direction shown in below
picture, unscrew the lamp.
6.
Fit new lamp in anti-clockwise direction, then
replace the lamp cover and screw.
Replacing the lamp
7.
Plug in the appliance and regulate the knob
to correct position.
1
Lamp
2
Screw
3
Lamp cover
ZRA25100WA_1602.indb 20
2016-02-25 08:24:05
