12
INSTALLATION
If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock
(latch), be sure to make that spring lock unusable
before you discard the old appliance. This will
prevent it from becoming a death-trap for a child.
Location
Place the appliance away from all heat sources, such
as: radiators, heating stoves, direct sunlight, etc.
Best results are obtained with a room temperature
ranging b16
°
C and +32
°
C.
For building-in instructions, see the relevant
section.
Electrical connection
Before you plug the appliance into a mains supply,
make sure that the voltage and frequency shown on
the rating plate correspond to your home supply.
A 6% fluctuation above or below the rated voltage is
admissible.
To adapt the appliance to other voltages, use a
suitable autotransformer.
It is essential that the appliance be connected to an
efficient earth tap.
For this purpose the supply cable plug incorporates
a special earth contact.
If the sockets of your domestic wiring system are
not grounded, have the appliance connected to a
separate ground wire by a qualified electrician in
accordance with the existing safety regulations.
The manufacturer declines to accept any liability should
this safety rule not be observed.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly. Do not use detergents which
will leave an odour or abrasive powders on the
interior, as these will damage the finish.
Door reversibility
(Fig.
1)
Before fitting the appliance in the kitchen furniture and
connecting it to the power supply, if necessary, change
the door opening side (from right to left). Proceed as
follows:
1. Place the appliance on its back, putting packing
material between it and the floor to avoid
damaging the appliance cooling pipes.
2. Unscrew the bolts.
3. Assemble the spacers and the bolts on the
opposite side.
Fig. 1
Building in
Recess dimensions
Height
1780 mm
Depth
550 mm
Width
560 mm
To ensure adequate ventilation, allow the clearances
shown in Fig.
2.
Fig. 2
D581
D027
50-min. cm
2
200
min.
cm
2
200
