16
TECHNICAL SPECIFICATIONS
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the serial number plate
correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For
operation with different voltages, a suitably sized auto-transformer must be used.
The technical data is indicated in the rating plate on the left side inside the appliance.
GB
D
E
D734
8mm
PR34
PR35
Open both the appliance door and that of the
kitchen unit to approx. 90°. Place the little plates
over the runners. Hold the doors of the appli-
ance and the unit together and mark the holes.
Remove the little plates and make the holes
with a diam. of 2 mm. Replace the little platee
over the runners and screw in the screws
provided (3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that
the doors of the appliance and the kitchen unit
open properly.
If the appliance is to be fitted laterally to the
kitchen unit, it will be sufficient to loosen the
screws of the little plates (G), move them as
shown in Fig. 10 and then fasten them up
again. Fit the cover (H).
The doors can be opened using the sliding
systempreviously illustrated, or one of the two
doors can be opened by fitting the small handle
supplied as an accessory.
Fig. 8
Fig. 9
Fig. 10
D029
Fig. 11
