33
Left hand door opening
Remove the upper right screw and pivot.
Straighten the safety washer (4) of the lower right
hinge. Remove the screw (5) and the pivot (6)
(Fig. 3). For safety reasons bend the washer located
under the left hinge (Fig. 4), by using a tool (for ex.
a screwdriver). Remove the right door stop hinge
(3-Fig. 3).
Fig. 4
Fitting the handle
Holes for fitting the handle on the opposite side are
provided, with fixing screws already in place.
Inner door reversal
Using a screwdriver release bracket (1) by pressing
on the internal spring (Fig. 5) and withdraw it from
its seat together with the door;
remove plug (2) and fit it in the hole left open on the
opposite side;
Fig. 5
turn the door
through 180
°
,
remove the
bracket (1) and
refit it on the
opposite side.
Refit the door and
insert the top pin
and bottom
bracket (1),
pushing it into
place.
To ensure correct storage of food, the door is fitted
with a simple spring device which holds it in the
open position until it is properly closed.
6
5
D563
4
PR140
1
2
180°
Building-in
Recess dimensions
ZPL 5233
Height
1225 mm
Depth
550 mm
Width
560 mm
For safety reasons, minimum ventilation must be as
shown in Fig. 6.
Attention: keep ventilation openings clear of obstruction
.
Fig. 6
Air is taken in through the ventilation grille at the
bottom of the appliance, but an air outlet “gap”,
measuring 50 mm deep by 540 mm wide (Fig. 7),
must be provided in the rear of the kitchen unit.
This outlet gap must also be kept clear between the
top of the unit and the ceiling.
Slide the refrigerator into the unit recess and fit the
screws into the top bracket (Fig. 8) and into the
bottom hinge (Fig. 8).
Fig. 7
Fig. 8
50 mm
min.
cm
2
200
200 cm
2
min.
D567
D240
P
H
L
50
540
D585
