Zanussi ZPC 428 D, Instruction Booklet

Page: 5 / 10

13
Left hand door opening
Remove the screws and the upper pivots. Lift off
the upper door. Remove the middle hinge (A-Fig. 2)
and fix it to the other side, after having removed the
little caps which cover the holes and which must be
refitted on the opposite side. Replace the upper
door and fix the screw and the upper left pivot into
place. Straighten the safety washer (4) of the lower
right hinge (Fig. 2a). Remove the screw and the
pivot (6-Fig. 2a). For safety reasons, bend the
safety washer located under the left hinge (Fig. 3),
by using a suitable tool (for ex. a screwdriver).
Remove the door’s top right hinge (3-Fig. 2a).
Fig. 3
Fitting door panels
To fit the door panel, proceed as follows:
Loosen the screws fixing the side frame (Fig. 4);
loosen all the other screws fixing the door frame;
insert the panel from the side on which the frame
has been removed and push it through;
refit the frame on the door again and tighten all the
screws.
Note:
The panel size should be 1-2 mm lower than the
door; the maximum panel thickness should be 4 mm.
Fig. 4
6
5
D563
4
D243
Building-in
The housing dimensions should be as follows:
Height 1580 mm
Minimum depth 550 mm
Minimum width 560 mm
Cooling air comes in through the ventilation grid at
the bottom of the appliance. To ensure air
circulation, leave a ventilation gap at the back of the
appliance, having the following dimensions:
depth: 50 mm, width: 540 mm (Fig. 5).
A similar gap must also be left in the top of the
kitchen furniture.
Fit the appliance into the housing and secure it with
the the top frame screws (Fig. 5a) and the bottom
hinge screws (Fig. 5a).
Fig. 5
Fig. 5a
Note
After having installed the appliance in the
appropriate space and having adjusted the opening
direction of the doors as required, remove block (3-
Fig. 2a) which is fitted on the side opposite the
hinge.
D592
P
H
L
50
540
D606