12
Fig. 6
Replacing the Oven Light
Ensure the electricity supply is switched off
before carrying out this operation.
The oven bulb has to comply to these features:
a) resistant to temperatures of 300 °C;
b) electric rate: 230 V - 50 Hz;
c) electric power rate:15 W;
d) connection type: E 14.
To replace the bulb, proceed as follows (fig. 7):
a)
push in and turn the glass lid anticlockwise;
b)
remove tha faulty bulb;
c)
replace it with a new one;
d)
refit the glass lid;
e)
switch on the electricity supply.
Fig. 7
FO 0287
The Hinged Grill
The oven is fitted with a hinged grill element, to enable
you to clean the roof of the oven easily.
Before proceeding ensure the oven is cool
and is isolated from the electricity supply.
l
Undo the screws which hold the grill in place (see
diagram 6). When doing this operation for the first
time, we recommend using a screwdriver.
l
Then gently pull the grill downward to allow access
to the oven roof.
l
Clean the oven roof with a suitable cleaner and wipe
dry before replacing the hinged grill element.
l
Gently push up the grill element into place and firmly
screw into place the holding nuts.
Ensure the grill holding nuts are firmly in
place to avoid the grill falling down when in
use.
General Cleaning
Before carrying out any cleaning or
manteinance work, always disconnect the
appliance from the electrical supply, and
allow it to cool down.
When using
spray
cleaning products, be careful not
to spread them on the heating elements or on the
thermostat sensor.
Never use harsh
abrasives
, steel wool or cleaners
with
bleach
, as they could damage the enamel and
the oven door glass.
The Oven Cavity
The enamelled oven cavity is best cleaned whilst the oven
is still warm. It is advisable to wipe the oven over with a soft
cloth soaked in warm soapy water after each use.
However, from time to time, it will be necessary to do a
more complete cleaning, using a proper oven cleaner.
In case of particularly tough stains, you can use stainless
steel cleaning products or some warm vinegar.
If cooking fruits,
some over-heated natual acids
can squeeze and settle on the oven enamel,
causing stains quite difficult to remove. This could
affect the enamel brightness, but it will have no
consequence on the oven performances.
To avoid these stains to be burnt out during the
next cooking, carefully clean the oven cavity after
all fruits cookings.
The Oven Door Gasket
The correct operation of the oven is ensured by a gasket
placed round the edge of the oven cavity.
Periodically
check
the condition of this gasket. If
necessary, clean it without using abrasive cleaning
products.
If the gasket shows to be
damaged
, call you local
Zanussi Service Centre. Do not use the oven until it
has been repaired.
Cleaning and Maintenance
