Zanussi ZOG10311XK, User Manual

Page: 15 / 24

A
REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem Possible cause Remedy
The oven does not heat up. The oven is off. Turn on the oven.
The oven does not heat up. The fuse is blown. Make sure that the fuse is the
cause of the malfunction. If the
fuse problem recurs, contact a
qualified electrician.
The oven does not work. The automatic ignition does
not work.
Light the burner with a long
match. Hold the flame near the
hole in the bottom of the oven
cavity. At the same time push
the knob for the gas control
and turn it counterclockwise to
the maximum temperature.
When the flame lights, keep
the knob for the gas control
pushed for 15 seconds or less
to warm up the thermocouple.
Otherwise the gas flow is in-
terrupted.
The lamp does not work. The lamp is broken. Replace the lamp.
Steam and condensation settle
on the food and in the oven
cavity.
A dish was left in the oven for
too long.
Food should not be left in the
oven for longer than 15-20 mi-
nutes after cooking.
The flame extinguishes immedi-
ately after ignition.
The thermocouple is not heat-
ed up.
After the flame lights, keep the
knob for the gas control push-
ed for 15 seconds or less.
15