Before activating the catalytic
cleaning remove all the accessories
from the oven.
The walls with a catalytic coating are self-
cleaning. They absorb fat which collects on the
walls while the appliance operates.
To support the self-cleaning procedure, heat
the empty oven on a regular basis.
1. Clean the oven floor with warm water and
washing up liquid, then dry it.
2. Set the function if applicable. If not, set
.
3. Set the temperature to 250ºC and let oven
operate for 1 hour.
4. When the appliance is cool, clean it with a
soft and moist sponge.
Removing and installing the door
You can remove the door and the internal glass
panels to clean it. The number of glass panels is
different for different models.
WARNING!
Be careful when you remove the
door from the appliance. The door is
heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on the
two door hinges.
A
A
3. Close the door until it is at an angle of
approximately 45°.
45°
4. Hold the door with one hand on each side
and pull it away from the appliance at an
upwards angle.
5. Put the door with the outer side down on a
soft cloth on a stable surface. This is to
prevent scratches.
6. Hold the door trim (B) on the top edge of
the door at the two sides and push inwards
to release the clip seal.
2
B
1
CAUTION!
Rough handling of the glass,
especially around the edges of the
front panel, can cause the glass to
break.
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
9. Clean the glass panel with water and soap.
Dry the glass panel carefully.
When the cleaning is completed, install the
glass panels and the door. Do the above steps
in the opposite sequence. Install the smaller
panel first, then the larger.
16
Summary of Contents for ZOF35511W
Page 1: ...EN ZOF35511W ZOF35511X User Manual Oven ...
Page 19: ...19 ...
