Zanussi ZOB 985 QP, Instruction Manual

Page: 21 / 25

84
Technical Data
Dimensions of recess
Height undertop: 593 mm; in coloumn 580 mm
Width 560 ÷ 570 mm
Depth 550 mm
Dimensions of the oven cavity
Height 335 mm
Width 405 mm
Depth 400 mm
Oven capacity 56 litres
This oven must be installed by qualified
personnel .
The oven must be installed according to the
instructions supplied.
Installation
Heating elements rating
Top element 800 W
Bottom element 1000 W
Convection element 2000 W
Grill element 1650 W
Double Grill element 2450 W
Pizza Oven Function 3000 W
Thermal Grilling 1680 W
Pyrolytic cleaning function 2450 W
Convection Fan 30 W
Oven Light 40 W
Cooling Fan 25 W
Total Rating 3080 W
Supply voltage (50 Hz) 230 V
Before the appliance is connected:
1) check that the main fuse and the domestic installation
can support the load;
2) check that the power supply is properly earthed in
compliance with the current rules;
3) check the double pole switch used for the electrical
connection can be easily reached with the appliance
built in the forniture unit.
The appliance is supplied with connection cable. A
proper plug, according to the electric load specified on
the rating plate, must be fitted to the cable.
In case of a direct connection to the mains, it is
necessary that you install a double pole switch between
the appliance and the electricity supply, with a minimum
gap of 3 mm. between the switch contacts and of a type
suitable for the required load in compliance with the
current rules. The yellow-green earth wire must not be
interrupted in any point and should be about 2 cm longer
than the neutral and phase wires.
The connection cable has to be placed in order that, in
each part, it cannot reach a temperature 50 °C higher
than the room temperature.
After the connection is carried out, test the heating
elements for about 3 minutes.
Should the supply cord need to be replaced, use only
the following cable types: H07 RN-F, H05 RN-F, H05
RR-F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F. The
yellow-green earth wire should be about 2 cm longer
than the neutral and phase wires.
Electrical connection
Terminal block
The oven has an easily accessible terminal block, which
is meant to work with an electric single-phase rate of 230
V (Fig. 26).
The manufacturer disclaims any responsability
should all the safety measures not be carried
out.
Fig. 26