Zanussi ZKK8023, User Manual

Page: 17 / 44

Problem Possible cause Solution
The temperature in the appli-
ance is too low. The temperature regulator is not set
correctly. Set a higher temperature.
The temperature in the appli-
ance is too high. The temperature regulator is not set
correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too high. Let the product temperature decrease
to room temperature before storage.
Many products are stored at the
same time. Store less products at the same time.
There is no cold air circulation in the
appliance. Make sure that there is cold air circu-
lation in the appliance.
Replacing the lamp
Caution! Disconnect the plug from the mains
socket.
1. Remove the screw
from the lamp cov-
er.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
lamp of the same
power (the maximum power is shown on the lamp
cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Force Center.
Technical data
Dimension of the recess
Height 1225 mm
Width 560 mm
Depth 550 mm
The technical information are situated in the rating plate
on the internal left side of the appliance and in the en-
ergy label.
Installation
Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
17