Any necessary adjustment can be made with a
spanner. Accurate levelling prevents vibration,
noise and displacement of the machine during
operation.
Never place cardboard, wood or similar
materials under the machine to compensate for
any unevenness in the floor.
Some vibration is inevitable, especially if
mounted on a wooden floor.
Sprung woden floors are particularly
susceptible to vibration. For advice, consult a
builder. If possible, always place the machine
on a solid floor.
Water inlet
Warning
This appliance must be connected to a cold
water supply.
1. Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the
appliance. The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
Do not use the hose from your previous
machine to connect to the water supply.
2. The other end of the inlet hose which
connects to the machine can be turned as
showed in the picture. Do not place the inlet
hose downwards. Angle the hose to the left
or right depending on the position of your
water tap
3.Set the hose
correctly by
loosening the ring
nut.
After positioning the
inlet hose, be sure to
tighten the ring nut
again to prevent
leaks.
IMPORTANT!
Before connecting up the machine to new
pipework or to pipework that has not been
used for some time, run off a reasonable
amount of water to flush out any debris that
may have collected in the pipes.
Water drainage
The end of the drain hose can be positioned in
three ways:
Hooked over the
edge of a sink using
the plastic hose
guide supplied with
the machine.
In this
case, make sure the
end cannot come
unhooked when the
machine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe
branch.
This branch
must be above the
trap so that the bend
is at least 60 cm
above the ground.
32
132960310.qxd 23/10/2008 12:09 Pagina 32
