Zanussi ZKG 2125, User Manual, Page: 22 / 32

6. press the two levers and pull forward the
drainage duct to let the water flow out;
7. when the container is full of water, put the
drainage duct back again and empty the
container;
repeat this operation until water stops flow-
ing out;
8. if necessary clean the pump (refer to the
section ‘Cleaning the pump’ );
9. close the drain pump door.
When you drain the water with the emergency
drain procedure, you must activate again the
drain system:
1. Put 2 litres of water in the main wash com-
partment of the detergent dispenser.
2. Start the programme to drain the water.
What to do if…
Certain problems are due to lack of simple
maintenance or oversights, which can be solved
easily without calling out an engineer. Before
contacting your local Service Centre, please
carry out the checks listed below.
During machine operation it is possible that the
red pilot light of button 7 blinks, one of the fol-
lowing alarm codes appears on the display and
some acoustic signals sound every 20 seconds
to indicate that the machine is not working:
•
: problem with the water supply.
•
: problem with the water draining.
•
: door open.
Once the problem has been eliminated, press
the button
7 to restart the programme. If after all
checks, the problem persists, contact your local
Service Centre.
Problem Possible cause/Solution
The washing machine does
not start:
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and/or the button
7 has not
been pressed.
• Please turn the selector dial and press the button 7 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
The Child Safety Lock has been activated.
• Deactivate the Child Safety Lock.
22
www.zanussi.com