•
An alarm code
indicates a fault in the machine
operation (see the relevant chapter on page 54).
11 RESET (ANUL.) button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the machine on, the blinking zero relevant to the end
of the previous cycle will reappear.
You can also press the RESET (ANUL.) button to
exclude one or several phases of the programme
which is running, as indicated below.
- set the machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the RESET (ANUL.) button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the name of the phase(s) will go
out).
Example:
In this case, only the
spin (at the speed
provided for the
selected type of fabric)
will be performed.
This button allows you also to select special
programmes, such as
RINSES
,
SPIN
and
DRAIN
.
•
If the machine is already switched on
because it
has just performed a washing programme, proceed
as follows:
- depress RESET (ANUL.) once or repeatidly to
cancel the previously performed programme (three
blinking dashes will appear on the display);
- select the type of fabric by means of button
TEJIDOS;
- select the special programme:
E20
•
RINSES and SPIN
Depress RESET (ANUL.)
once
, the pilot light
(WASH) goes out.
•
SPIN
Depress RESET (ANUL.)
twice
, the pilot lights
WASH and
RINSES go
out.
•
DRAIN
Depress RESET (ANUL.)
three times
, the pilot
lights WASH
, RINSES
and SPIN
go
out and the only pilot light
will remain lit.
Example:
In this case the
machine will perform
the rinses and spin.
•
If the machine is switched off:
- depress ON/OFF button to switch it on;
- select the type of fabric by means of button
TEJIDOS:
- select the special programme as previously
described.
12 DELAY (RETARDO) button
This button makes it possible to delay the starting of
the programme from 30 min - 60 min - 90 min, 2
hours and then by 1 hour up to a maximum of 23
hours.
The delay you have selected is shown on the display
for about 3 seconds; afterwards, the duration of the
programme reappears.
You must select this option
after
you have set the
programme and
before
you press the
START/PAUSE button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment
,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to
cancel
the delay time,
proceed as follows:
• set the machine to PAUSE by pressing the
START/PAUSE button;
40
