56
Position the runners (A) at the top and bottom of the
inside of the kitchen unit as shown in Fig. and mark
the position of the external holes.
After preparing the holes, screw the runners to the
kitchen unit door using 3.5x16 mm screws.
Open both the appliance door and that of the kitchen
unit to approx. 90¡. Place the little plates over the
runners. Hold the doors of the appliance and the unit
together and mark the holes.
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little platee over the
runners and screw in the screws provided (3.5x16
mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that the
doors of the appliance and the kitchen unit open
properly.
If the appliance is to be fitted laterally to the kitchen
unit, it will be sufficient to loosen the screws of the
little plates (D), move them as shown in Fig. and
then fasten them up again. Fit the cover (E).
PR33
20mm
A
8mm
PR34
PR35
D
E
D734
