15
INSTALLATION
If this appliance featuring magnetic door seals
is to replace an older appliance having a spring
lock (latch) on the door or lid, be sure to make
that spring lock unusable before you discard
the old appliance.
This will prevent it from becoming a death-trap
for a child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature b18
°
C and +43
°
C (class T);
+18
°
C and +38
°
C (class ST); +16
°
C and +32
°
C
(class N); +10
°
C and +32
°
C (class SN).
The class of your appliance is shown on its
rating plate.
For building into kitchen units follow the special
“Building-in” instructions given.
Important
It is essential that the appliance be connected to an
efficient earth tap. For this purpose the supply
cable plug incorporates a special earth contact. If
the sockets of your domestic wiring system are not
earthed, have the appliance connected to a
separate earth wire by a qualified electrician in
accordance with existing safety regulations.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio
interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive)
and subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly.
Do not use detergents or abrasive powders, as
these will damage the finish.
Instructions for totally built-in
appliances
Dimensions of the recess
Height
880 mm
Depth
550 mm
Width
560 mm
The appliance’s door has been locked in
position for transport by means of pins on
both sides. According to the door opening
direction, remove relevant pins at the top and
at the bottom.
For safety reasons, minimum ventilation must be
as shown in Fig. 1.
Attention: keep ventilation openings clear of
obstruction.
Fig. 1
50 mm
min.
cm
2
200
200 cm
2
min.
D567
GB
