Zanussi ZHT800X, Operating Instruction

Page: 23 / 32

Installation Guidelines
6
7
0
0
m
m
±
5
0
m
m
( FIG. 1 )
( FIG. 2 )
Exhaust
duct
( FIG. 3 )
696mm
664mm
228mm
( FIG. 4 )
( FIG. 5 )
( FIG. 6 )
B. Installation
(FIG. 1) 1. Location:
the effectiveness of hood.To suggest close
window/door before use hood.
the range of suction efficiency.
• The smoke has to rise up to 25 cm to be within
• Air turbulence is from window/door may reduce
2. Position: (FIG. 2)
from center of fan grille of hood to the top of
the stove.
• The minimum installation height should not
be less than 650mm and the recommended
height is 700±50 mm.
• Avoid left-right or front-dropped inclination. • The installation height is measured vertically
3. Exhaust duct: (FIG. 3)
enclosed in the packaging can be used.
• Before installing the hood,please apply fast
drying glue to the collar and securely attach
it to the top of the cooker hood’s vent lid.
Install the cooker hood and exhaust duct to
the plastic collar and seal with fast drying
glue.
• 6-inch diameter exhaust duct is recommended
to use in order to maximize suction efficiency.
In case of 5-inch exhaust duct, an adapter as
C. Mounting Method
1. Rear mounting
• Use 2 wooden screws and 2 washers to secure
the hood to the wall. (See FIG. 4)
2. Top mounting(Only for ZHT850X and ZHT900X)
hood onto screws located on cabinet bottom
hood to cabinet. (See FIG. 5)
of hood's top (See FIG. 6).
(Note: Make sure all 4 key-holes cover the
the hood to the bottom of the cabinet. Lift
screws and each screw was tightened.
Otherwise, there will be potential risk of
machine fall down.)
and lock into place. Make sure all 4 key-holes
• Use 4 wooden screws and 4 washers to secure
cover the screws. Tighten each screw to secure
Stick the two round rubber stands on the sides