Zanussi ZHC 935, Instruction Booklet

Page: 13 / 20

13
Fitting the Wall Brackets
Draw a vertical line on the wall from the centre of
the cooking appliance up to the ceiling, or as high
as the adjoing wall cabinets using a spirit level
and marker pen. This is to ensure the correct
vertical alignment of the appliance.
- Draw a horizontal line 965mm above the
hob (for installation without the optional
splashback) or
- 965mm above the surface on which the
splashback will be seated (for installation
with the optional splashback).
- Place bracket item 7.2.1 on the wall as
shown about 1-2mm from the ceiling or
upper limit aligning-notch in the centre of
the bracket with the vertical line.
Mark the hole centres for the bracket
fixing screws on the wall.
- Place bracket item 7.2.1 on the wall as
shown at 215mm below the first bracket
at X.
- Mark the hole centres for the bracket
fixing screws on the wall.
INSTALLING THE COOKER HOOD
- Mark a hole centre on the horizontal line
965mm above the worktop, 116mm either
side of the vertical line as indicated.
- Drill the holes marked on the wall using a
Ø8mm drill-bit.
- Fix the two brackets item 7.2.1.
965
X
116
1
-
2 mm
116
965 min.
7.2.1