Zanussi ZHC 926 X, Installation, Use And Maintenance Handbook

Page: 5 / 9

14
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
GB
to spigot R ). Make sure that the height of
the assembly R + P corresponds to the
height of the chimney outlet ( fig. 6 ).
• If the hood is supplied with the activated
charcoal filters fitted, the filters should be
removed (see paragraph on Maintenance ).
• Recirculation fitting
• The filtered air is returned to the room
through the two plastic side grills G on the
lower chimney element I .
• Connect the additional spigot P to the round
fan outlet, pushing it downwards, and fit
spigot
R to additional spigot P in a similar
manner (make sure that the two additional
side recirculation spigots
P1 are fitted to
spigot R ). Cut the additional spigot P in
correspondence with outlets 1 and 2 , which
must be formed directly on the piece. Make
sure that the height of the assembly
R + P
corresponds to the height of the chimney
outlet.(
fig.6 ).
• Fit the activated charcoal filters inside the
canopy (see paragraph on Maintenance ). Do
not fit the venting grilles until after the chimney
has been installed.
Fitting the telescopic chimney
• To fit the upper section S first expand the two
side pieces slightly, hook them behind the
brackets 2 and close them together again until
they touch. Fix the upper section S to the
brackets 2 using four of the screws provided
in the bag of accessories (
fig. 7 ).
• Fit the lower section I as above, between the
upper section S and the canopy C using two
of the screws provided in the bag of
accessories.
• Chimney with venting grilles: Snap the venting
grilles into position in the apertures located
on the chimney section, so that the symbol
is turned upwards and the symbol faces
forwards. Also, when the hood is used in
recirculation mode, ensure that the grilles are
properly secured to the inside of the
recirculation spigot
R ( fig.8 ).
R
P1 P1
P
G
R
P1 P1
P
G
G
A18_
714_0
3
2
S
I
2
C
G
A18_
714_0
3
2
S
I
2
C
Fig. 8
Fig. 6
Fig. 7