Zanussi ZGX65424XA, User Manual

Page: 10 / 20

If there are other fuel burning appliances in the
same room, B.S. 5440 Part 2 Current Edition,
should be consulted to determine the requisite
air vent requirements.
For appliances installed in the Republic of Ire-
land please refer to the NSAI- Domestic Gas In-
stallation I.S. 813 Current Editions Table Four.
Location
The hob may be located in a kitchen, a kitchen/
diner or bed sitting room (with a volume greater
than 20 m³), but not in a bathroom or shower
room.
The minimum distance combustible material can
be fitted above the hob in line with the edges of
the hob is 400 mm. If it is fitted below 400 mm
a space of 50 mm must be allowed from the
edges of the hob.
For appliances installed in the Republic of Ire-
land please refer to NSAI- Domestic Gas Instal-
lation I.S 813 Current Edition Section 7- Per-
mitted Locations of Appliance.
Gas Connection
Warning! Any gas installation must be
carried out by a GAS SAFE REGISTER
installer.
Make sure that, once the hob is installed, it is
easily accessible for the engineer in the event of
a breakdown.
The manufacturer will not accept liability, should
the above instructions or any of the other safety
instructions incorporated in this instruction
booklet be ignored.
On the end of the shaft, which includes the G
1/2" threaded elbow, adjustment is fixed so that
the washer is fitted between the components as
shown in the diagram. Screw the parts together
without using excessive force.
A B C
A) End of shaft with nut
B) Washer
C) Elbow
Connection to the gas supply should be with ei-
ther rigid or semi-rigid pipe, i.e. steel or copper.
The connection should be suitable for connect-
ing to R 1/2 (1/2 BSP male thread).
When the final connection has been made, it is
essential that a thorough leak test is carried out
on the hob and installation.
Make sure that the main connection pipe does
not exert any strain on the hob.
If you use flexible metal pipes make sure that
they agree to ISO 10380 and ISO 10807
standards. Be careful they do not come in touch
with mobile parts or they are not squeezed. Also
be careful when the hob is put together with an
oven.
Important! It is important to install the elbow
correctly, with the shoulder on the end of the
thread, fitted to the hob connecting pipe.
Important! Failure to ensure the correct
assembly will cause leakage of gas.
Important! Make sure that the gas supply
pressure of the appliance obeys the
recommended values.
Rigid connection:
Carry out connection by using metal rigid pipes
(copper with mechanical end).
Injectors replacement
1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
3. With a socket spanner 7 remove the injec-
tors and replace them with the ones which
are necessary for the type of gas you use
10
www.zanussi.com