Zanussi ZGNN645K, User Manual

Page: 12 / 20

CAUTION! In the absence of
electricity you can ignite the burner
without electrical device; in this case
approach the burner with a flame, turn
the control knob counter-clockwise to
maximum gas supply position and
push it down. Keep the control knob
pushed for equal or less than 10
seconds to let the thermocouple warm
up.
If the burner accidentally goes out,
turn the control knob to the off position
and try to light the burner again after
minimum 1 minute.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut.
It is normal.
The hob is supplied with the
progressive valves. They make the
flame regulation more precise.
TURNING THE BURNER OFF
To put the flame out, turn the knob to the off
position .
WARNING! Always turn the flame
down or switch it off before you
remove the pans from the burner.
HINTS AND TIPS
WARNING! Refer to Safety chapters.
COOKWARE
CAUTION! Do not use cast iron pans,
clay or earthenware pots, grill or
toaster plates. The stainless steel can
become tarnished if it is too much
heated.
WARNING! Do not put the same pan
on two burners.
WARNING! Do not put unstable or
damaged pots on the burner to
prevent spills and injuries.
CAUTION! Make sure that the
bottoms of pots do not stand too
close to the control knob, otherwise
the flame heats the control knob up.
CAUTION! Make sure that pot
handles are not above the front edge
of the cooktop.
CAUTION! Make sure that the pots
are placed centrally on the burner in
order to get the maximum stability and
a lower gas consumption.
DIAMETERS OF COOKWARE
Use cookware with diameters
applicable to the size of burners.
Burner
Diameter of cook-
ware (mm)
Multi Crown 180 - 260
Semi-rapid 120 - 220
Auxiliary 80 - 180
12