9
Before fitting the hob into the cut out, an adhesive
seal must be fitted to the underside outside edge
of the hob. It is essential that no gaps are left in
this seal in order to prevent spillage near the hob
seeping into the cabinet below.
1)
Remove the pan supports, the burners caps
and crowns and turn the hob upside down, taking
care the ignition candles are not damaged in this
operation.
2)
Place the relevant sealing all around the
glass top edge, taking care that the sealings meet
without overlapping (Fig. 8).
3)
Place the hob in the cut out, taking care of
its centring.
4)
Fix the hob with the relevant screws (Fig. 9).
FO 2108
Fitting the hob to
the worktop
Electrical connections
A)
Sealing gasket
Any electrical work required to install
this appliance should be carried out by
a qualified electrician or competent
person, in accordance with the current
regulations.
THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability
should these safety measures not be
observed.
This appliance is designed to be
connected to a 230 V 50Hz AC electrical
supply.
Before the appliance is connected:
1) check that the main fuse and the domestic
installation can support the load (see the rating
label);
2) check that the power supply is properly earthed
in compliance with the current rules;
3) check the socket or the double pole switch used
for the electrical connection can be easily
reached with the appliance built in the forniture
Permanent Connection
In the case of a permanent connection, it is
necessary that you install a double pole switch
between the appliance and the electricity supply
(mains), with a minimum gap of 3 mm. between
the switch contacts and of a type suitable for
the required load in compliance with the current
electric regulations.
The switch must not break the yellow and green
earth cable at any point.
Ensure that the hob supply cord
does not come into contact with
surfaces with temperatures higher
than 50 deg. C.
unit. Before switching on, make sure the
electricity supply voltage is the same as that
indicated on the appliance rating plate. The
rating plate is located on the bottom of the hob.
A copy is attached on the back cover of this
book.
The appliance is supplied with a 3 core flexible
supply cord incorporating a plug. Connect the
plug to an adequate socket.
a
