8
Lighting the burners
Lighting the burners
Lighting the burners
Lighting the burners
Lighting the burners
For easier lighting, proceed before
putting a pan on the pan support.
To light a burner:
z
turn the relevant knob anti-clockwise to
maximum position (
), then push it
down to ignite the burner.
z
Upon ignition, keep the knob pushed
down about
5 seconds
. This will
allow the "thermocouple" (see Fig.1 -
letter
D
) to be heated and the safety
device to be switched off, otherwise
the gas supply would be interrupted.
z
Then adjust the flame as required.
I
f the burner accidentally goes out, turn
the control knob to the "off" position
and wait for at least
1 minute
before
trying to light the burner again.
If you cannot light the flame even after
several attempts, check the "cap"
(see Fig.1 - letter
A
) and the"crown"
(see Fig.1 - letter
B
) are in the correct
position.
To switch off a burner:
z
To put the flame out, turn the knob to the
symbol (
z
).
)
Operation
Operation
Operation
Operation
Operation
Hob burners control knobs
Hob burners control knobs
Hob burners control knobs
Hob burners control knobs
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply (“off” position)
there is maximum gas supply
there is minimum gas supply
z
A
A
A
A
A - Burner cap
B
B
B
B
B - Burner crown
C
C
C
C
C - Ignition electrode
D
D
D
D
D - Thermocouple
Fig. 1
A
B
C
D
Triple crown burner
)
