13
INSTALLATION
If this appliance featuring magnetic door seals is to replace an
older appliance having a spring lock (latch) on the door or lid,
be sure to make that spring lock unusable before you discard
the old appliance.
This will prevent it from becoming a death-trap for a child.
Location
Place the appliance away from all heat sources, such
as: radiators, heating stoves, direct sunlight, etc.
The best results are achieved with a room
temperature ranging from +18
°
C to +38
°
C
(class ST) or from +18
°
C to +43
°
C (class T). The
class of your appliance is shown on its rating plate.
Make sure that there is nothing at the back, at the
top and at the bottom of the appliance to obstruct
air circulation.
For a more efficient operation of the appliance, the
minimum distance between the top of the appliance
and other overhanging kitchen furniture, if any,
should be at least 100 mm (see Fig. 1-A).
However, the best solution would be that shown in
Fig. 1-B with no overhanging furniture.
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
Fig. 1
Rear spacers
In the bag with the documentation, there are two spacers which
must be fitted in the two top corners.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
Fig. 2
D245
A
B
100 mm min.
D594
Electrical connection
Before you plug the appliance into an A.C. mains
supply, make sure that the voltage and frequency
shown on the rating plate correspond to your home
supply.
A 6% fluctuation above or below the rated voltage is
admissible.
To adapt the appliance to other voltages, use an
autotransformer having a minimum output of
500 VA.
Important
It is essential that the appliance be connected to an
efficient earth tap. For this purpose the supply cable
plug incorporates a special earth contact. If the
sockets of your domestic wiring system are not
grounded, have the appliance connected to a
separate ground wire by a qualified electrician in
accordance with the existing safety regulations.
The manufacturer declines to accept any liability should this
safety rule not be observed.
This appliance complies with E.E.C. directive
No. 87/308 of 2.6.87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC
of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
-
89/336 EEC
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly. Do not use detergents which
will leave an odour or abrasive powders on the
interior, as these will damage the finish.
