Problem
Possible cause
Remedy
The hob deactivates.
You put something on the sen-
sor field .
Remove the object from the
sensor field.
Residual heat indicator does
not come on.
The zone is not hot because it
operated only for a short time.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
The sensor fields become hot.
The cookware is too large or
you put it too near to the con-
trols.
Put large cookware on the rear
zones if possible.
comes on.
Automatic Switch Off oper-
ates.
Deactivate the hob and acti-
vate it again.
comes on.
The Child Safety Device func-
tion operates.
Refer to "Daily use" chapter.
and a number come on.
There is an error in the hob.
Disconnect the hob from the
electrical supply for some time.
Disconnect the fuse from the
electrical system of the house.
Connect it again. If comes
on again, speak to an Author-
ised Service Centre.
E6 comes on.
The second phase of the pow-
er supply is missing.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse, wait
one minute, and insert the fuse
again.
IF YOU CANNOT FIND A SOLUTION...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre. Give the data from the rating plate. Give
also three digit letter code for the glass ceramic (it
is in the corner of the glass surface) and an error
message that comes on. Make sure, you operated
the hob correctly. If not the servicing by a service
technician or dealer will not be free of charge, also
during the warranty period. The instructions about
the Service Centre and conditions of guarantee are
in the guarantee booklet.
INSTALLATION
WARNING! Refer to Safety chapters.
BEFORE THE INSTALLATION
Before you install the hob, write down the
information bellow from the rating plate. The rating
plate is on the bottom of the hob.
Serial number ...........................
BUILT-IN HOBS
Only use the built-in hobs after you assemble the
hob into correct built-in units and work surfaces
that align to the standards.
CONNECTION CABLE
• The hob is supplied with a connection cable.
• To replace the damaged mains cable use the
following (or higher) mains cable type:
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
21
Summary of Contents for ZEV6340NBA
