Zanussi ZEAN82FR, User Manual

Page: 13 / 20

Problem Possible cause Solution
The temperature in the appli-
ance is too high.
Refer to "Door Open Alarm" or
"High Temperature Alarm".
The door is left open. Close the door.
The compressor operates con-
tinually.
Temperature is set incorrectly. Refer to "Control Panel" chap-
ter.
Many food products were put
in at the same time.
Wait a few hours and then
check the temperature again.
The room temperature is too
high.
Refer to "Installation" chapter.
Food products placed in the
appliance were too warm.
Allow food products to cool to
room temperature before stor-
ing.
The door is not closed correct-
ly.
Refer to "Closing the door"
section.
The FastFreeze function is
switched on.
Refer to "FastFreeze function"
section.
The compressor does not start
immediately after pressing the
"FastFreeze", or after changing
the temperature.
The compressor starts after a
period of time.
This is normal, no error has oc-
curred.
Door is misaligned or interferes
with ventilation grill.
The appliance is not levelled. Refer to installation instruc-
tions.
Door does not open easily. You attempted to re-open the
door immediately after closing.
Wait a few seconds between
closing and re-opening of the
door.
The lamp does not work. The lamp is in stand-by mode. Close and open the door.
The lamp is defective. Contact the nearest Author-
ized Service Centre.
There is too much frost and
ice.
The door is not closed correct-
ly.
Refer to "Closing the door"
section.
The gasket is deformed or
dirty.
Refer to "Closing the door"
section.
Food products are not wrap-
ped properly.
Wrap the food products better.
Temperature is set incorrectly. Refer to "Control Panel" chap-
ter.
Appliance is fully loaded and is
set to the lowest temperature.
Set a higher temperature. Re-
fer to "Control Panel" chapter.
13