INSTALLATION
PIN24GB
4
Remove all packaging before positioning the
machine.
Positioning
(ZDW 416 FS)
If possible, position the machine next to a water tap
and a drain.
The sides and the back of the dishwasher can rest
against the adjacent furniture or the wall.
The dishwasher features fill and drain hoses which
can be turned either to the left or the right to suit the
installation.
Levelling
(ZDW 416 FS)
Good levelling is essential for correct closure and
sealing of the door.
If the door does not close correctly, loosen or tighten
the adjustable support feet, until the machine is
perfectly level.
Adjusting the worktop
(ZDW 416 FS)
You can move the worktop forward or backward by 25
mm in order to align the machine with other kitchen
units.
Simply unscrew the two front retaining screws, move
the top to the required position and then retighten the
screws.
Installing and securing the machine under a
kitchen unit
(ZDW 416 FS)
(sink-worktop unit)
By removing the machine's worktop, you can install it
under a close fitting sink unit or a pre-existing top, if
the dimensions of the recess correspond to those
shown in the picture.
Then proceed as follows:
Remove the machine worktop by unscrewing the two
front retaining screws, pull from the front and slide out
the rear slots, lifting the worktop.
Insert the machine after adjusting the height and level-
ling with the adjustable feet. When inserting the ma-
chine, ensure that the water inlet and drain hoses are
not kinked or squashed.
Caution
Once the machine has been installed, ensure that it
can be accessed easily for servicing.
Fitting a decor panel on the door
(ZDW 416 FS - ZDW 416 BU)
The door of this machine has frames for fitting a
plastic laminate decor panel in the colour required to
match the dishwasher with the rest of the kitchen
furniture. If you wish to do this you must provide the
panel yourself.
Width:
588 mm
Height:
586 mm
Max thickness:
4 mm
To fit the panel
Take the door frame off
after removing the retain-
ing screws around the
edge.
Position the panel, refit
the frame and tighten the
retaining screws around
the edge.
Note:
The panel should be fitted before positioning the machine.
IN01
IN03
820
570
÷
600
600
IN05
AP01
