German degrees
(°dH)
French degrees
(°fH)
mmol/l
Clarke degrees
Water softener
level
4 - 10
7 - 18
0.7 - 1.8
5 - 12
2
<4
<7
<0.7
< 5
1
2)
1)
Factory setting
2)
Do not use salt at this level.
ACTIVATING THE ACOUSTIC SIGNAL FOR THE END OF PROGRAMME
By default this acoustic signal is deactivated but it is possible to activate it.
1.
While the appliance is in user mode, within about 5 seconds press programme button: the indicator
is on and the indicator
starts to flash.
2.
Wait until the indicator goes off. The indicator
is off. The acoustic signal is off.
3.
Press programme button to change the setting. The indicator
is on. The acoustic signal is on.
4.
Press on/off button to confirm the setting.
BEFORE FIRST USE
1.
Make sure that the current level of the water
softener agrees with the hardness of the water
supply. If not, adjust the level of the water
softener.
2.
Fill the salt container.
3.
Fill the rinse aid dispenser.
4.
Open the water tap.
5.
Start a programme to remove any processing
residuals that can still be inside the appliance.
Do not use detergent and do not load the
baskets.
When you start a programme, the appliance can
take up to 5 minutes to recharge the resin in the
water softener. It seems that the appliance is not
working. The washing phase starts only after this
procedure is completed. The procedure will be
repeated periodically.
51
Summary of Contents for ZDV12002FA
Page 71: ...71 ...
