With some problems, the display shows
an alarm code:
•
- The appliance does not fill with water.
•
- The appliance does not drain the wa-
ter.
•
- The anti-flood device is on.
Warning!
Deactivate the appliance
before you do the checks.
Problem
Possible cause
Possible solution
The programme does not
start.
The mains plug is not connected in
the mains socket.
Connect the mains plug.
The appliance door is open.
Close the appliance door.
The fuse in the fuse box is damaged.
Replace the fuse.
The delay start is set.
Cancel the delay start or wait for the
end of the countdown.
The appliance does not fill
with water.
The water tap is closed.
Open the water tap.
The water pressure is too low.
Contact your local water authority.
The water tap is clogged or there is
limescale on it.
Clean the water tap.
The filter in the water inlet hose is
clogged.
Clean the filter.
The water inlet hose has a kink or a
bend.
Make sure that the position of the
hose is correct.
The anti-flood device is on. There are
water leakages in the appliance.
Close the water tap and contact the
Service.
The appliance does not
drain the water.
The sink spigot is clogged.
Clean the sink spigot.
The water drain hose has a kink or a
bend.
Make sure that the position of the
hose is correct.
After the checks are completed, activate the
appliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.
If the display shows other alarm codes, con-
tact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a low-
er position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not suf-
ficient. Adjust the rinse aid selector to a
higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase or
with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
activate the rinse aid dispenser and use
25
www.zanussi.com
