Zanussi ZDT 5044, Instruction Book

Page: 14 / 24

In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off push button
All the indicator lights of the programme selection push
buttons illuminate (setting mode).
4. Setting and starting the programme
To select a programme, press the programme push button
of the washing programme you wish to select (see
"Washing programmes" chart).
The corresponding indicator light remains illuminated while
the other programme push buttons indicator lights turn off.
The start of the programme will occur only after the
closure of the door, until this moment you can modify the
selection made.
Close the dishwasher door, the programme will start
automatically.
5. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it’s absolutely necessary
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
Interrupt a washing programme in progress
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point in
which it was interrupted.
Cancel a washing programme in progress
Open the dishwasher door.
Press simultaneously the function push buttons 2 and 3
for about 2 seconds, the indicator light of the push button
corresponding to the running programme starts flashing for
about 2 seconds.
After about 2 seconds the indicator lights of all the
programme push buttons will illuminate indicating that the
running programme has been cancelled and that the
machine has returned to setting mode.
(If a new washing programme will be selected, check that
there is detergent in the detergent dispenser).
6. End of the washing programme
The dishwasher will automatically stop and an audible
signal informs you of the end of the washing programme.
Hot steam may escape from the appliance when opening
the door immediately after the end of the programme,
therefore, open the door carefully.
The end of programme indicator light is illuminated.
The indicator light of the programme just ended remains
on.
Switch off the dishwasher by pressing the On/Off push
button.
7. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Starting a washing programme
14