Zanussi ZDT 312, User Manual

Page: 20 / 28

Fault code and malfunction Possible cause and solution
• 1 intermittent audible signal
• continuous flashing of the light of the running
programme
• 1 flash of the "end of programme " indicator light
The dishwasher does not fill with water.
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the threaded hose fitting
at the water inlet valve is blocked.
Clean the filter in the threaded hose fitting.
• The water inlet hose has not been correctly laid or
it is bent or squashed.
Check the water inlet hose connection.
•
2 intermittent audible signals
• continuous flashing of the light of the running
programme
• 2 flashes of the "end of programme " indicator
light
The dishwasher will not drain.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid or
it is bent or squashed.
Check the water drain hose connection.
• 3 intermittent audible signals
• continuous flashing of the light of the running
programme
• 3 flashes of the "end of programme" indicator
light
Anti-flood device is activated
Close the water tap and contact your local Service
Force Centre.
The programme does not start. • The dishwasher door has not been properly closed.
Close the door.
• The main plug is not plugged in.
Insert the mains plug.
• The fuse has blown in the household fuse box.
Replace the fuse.
Once these checks have been carried out;
switch on the dishwasher. The programme will
continue from the point at which it was inter-
rupted.
If the malfunction or fault code reappears con-
tact the Service Force Centre. For other fault codes not described in the above
chart, please contact your Service Force Cen-
tre.
20