AirDry is automatically activated with all
programmes other than Pre-rinse.
CAUTION! Do not try to close the
appliance door within 2 minutes after
automatic opening. This can cause
damage to the appliance.
CAUTION! If children have access to
the appliance, we advise to deactivate
AirDry. The automatic opening of the
door may pose a danger.
When AirDry opens the door, Beam-
on-Floor might not be completely
visible. To see if the programme is
complete, look at the control panel.
KEY TONES
The buttons on the control panel make a click
sound when you press them. You can deactivate
this sound.
LATEST PROGRAMME SELECTION
You can set the automatic selection of the most
recently used programme and options.
The latest programme that was completed before
the appliance deactivation is saved. It is then
selected automatically after you activate the
appliance.
When the latest programme selection is disabled,
the default programme is ECO.
SETTING MODE
How to enter setting mode
You can enter setting mode before starting a
programme. You cannot enter setting mode while
the programme is running.
To enter setting mode, press and hold
simultaneously 30 min and ECO for about 3
seconds.
• The lights related to 60 min, 90 min and
160 min are on.
• The display shows the current value of the
first available setting.
How to navigate in setting mode
You can navigate in setting mode using programme
buttons.
C
A
B
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch between the
basic settings and to change their value.
Use OK to enter the selected setting and to
confirm changing its value.
How to change a setting
Make sure the appliance is in setting mode.
1. Use Previous or Next to select the desired
setting.
The display shows the current setting value (a digit
and the dedicated letter).
2. Press OK to enter the setting.
The current setting value flashes.
3. Press Previous or Next to change the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic settings
list.
5. Press and hold simultaneously 30 min and
ECO for about 3 seconds to exit setting mode.
The appliance returns to the programme selection.
The saved settings remain valid until you change
them again.
BEFORE FIRST USE
1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme 30 min to remove any
residuals from the manufacturing process. Do
not use detergent and do not put dishes in the
baskets.
After starting the programme, the appliance
recharges the resin in the water softener for up to 5
minutes. The washing phase starts only after this
12
