Zanussi ZDLN1522, User Manual

Page: 14 / 28

8.3 How to fill the rinse aid
dispenser
M AX
1
2
3
4
+ -
A B
D
C
CAUTION!
The compartment (A) is for rinse aid only.
Do not fill it with detergent.
CAUTION!
Only use rinse aid designed specifically
for dishwashers.
1. Press the release button (D) to open the
lid (C).
2. Fill the dispenser (A) until the rinse aid
reaches the marking ''MAX''.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent excessive
foam formation.
4. Close the lid. Make sure that the release
button locks into position.
You can turn the selector of the released
quantity (B) between position 1 (lowest
quantity) and position 4 or 6 (highest
quantity).
9. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
Make sure that the appliance is in programme
selection mode.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme for
the type of load and the degree of soil.
9.1 Using the detergent
20
30
A B
C
CAUTION!
Only use detergent specifically designed
for dishwashers.
1. Press the release button (B) to open the
lid (C).
2. Put the detergent, in powder or tablets, in
the compartment (A).
3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the release
button locks into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a load
with normal soil.
Do not fill the compartment (A) with more
than 30 ml of gel detergent.
14 ENGLISH