Zanussi ZDI12001, User Manual

Page: 8 / 16

When you use tablets, that contain salt and rinse aid, do
not fill the salt container and the rinse aid dispenser. The
rinse aid indicator always comes on if the rinse aid dis-
penser is empty.
1. Adjust the water softener to the lowest level.
2. Set the rinse aid dispenser to the lowest position.
If you stop to use the combi detergent tablets, before you
start to use separately detergent, rinse aid and dishwasher
salt, do these steps:
1. Turn the programme knob until the programme mark-
er is aligned with the shortest programme with a rins-
ing phase.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the rinse aid
dispenser are full.
4. Start the set programme, without detergent and with-
out dishes.
5. Adjust the water softener to the water hardness in
your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to start a
programme.
• Turn the programme knob until the programme marker
is aligned with a programme on the control panel. If the
on/off indicator comes on and the phase indicators for
the programme start to flash, the appliance is in setting
mode.
• Turn the programme knob until the programme marker
is aligned with a programme on the control panel. If the
on/off indicator and the start indicator come on and a
phase indicator is on with fixed light, the appliance is
not in setting mode.
To put the appliance in setting mode, press and hold the
start button until the start indicator goes off and the phase
indicators for the programme start to flash.
Starting a programme without delay start
1. Open the water tap.
2. Close the appliance door.
3. Turn the programme knob until the programme mark-
er is aligned with the programme you want to set.
• The on/off indicator comes on.
• The phase indicators of the set programme start to
flash.
4. Press the start button. The programme starts.
• The start indicator comes on.
• Only the indicator of the phase in operation stays
on.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button to delay the start of the pro-
gramme of 3 hours. The delay indicator comes on.
3. Press the start button. The countdown starts.
• The start indicator comes on.
• The phase indicators of the set programme go off.
• When the countdown is completed, the programme
starts.
– The indicator of the phase in operation comes on.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you close
the door, the appliance continues from the point of inter-
ruption.
Cancelling the delay start while the countdown operates
1. Press and hold the start button until the start indicator
and the delay indicator go off.
• The phase indicators of the set programme start to
flash.
2. Press the start button. The programme starts.
• The start indicator comes on.
• Only the indicator of the phase in operation stays
on.
Cancelling the programme
Press and hold the start button until the start indicator
goes off and the phase indicators for the programme start
to flash.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
At the end of the programme
When the programme is completed, the end indicator
comes on.
1. To deactivate the appliance, turn the programme knob
until the programme marker is aligned with the on/off
indicator.
8