Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
1
2
Fully clean the filters A, B
and C below running wa-
ter.
3
To remove filters B and
C, turn the handle approx-
imately 1/4 anticlockwise.
4
Remove the flat filter A
from the bottom of the ap-
pliance.
5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
6
Put the filter system in po-
sition. To lock the filter
system, turn the handle
clockwise until it locks in
position.
Important! Do not remove the spray arms.
If the holes in the spray arms become clogged, remove
remaining parts of soil with a cocktail stick.
External cleaning
Clean the external surfaces of the appliance and control
panel with a damp soft cloth. Only use neutral deter-
gents. Do not use abrasive products, scouring pads or
solvents (acetone, trichloroethylene etc...).
Frost precautions
Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is
not responsible for damage because of frost.
If not possible, empty the appliance and close the door.
Disconnect the water inlet hose and remove water from
the water inlet hose.
What to do if…
The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the prob-
lem yourself. If you cannot find a solution to the prob-
lem yourself, contact the Service Force Centre.
13
