permitted ambient temperature
+ 5°C to + 35°C
1) 7 kg of cotton, centrifuged at 1000 rpm with reference to EN 61121
Installation
Appliance positioning
• It is recommended that, for your convenience, the ap-
pliance is positioned close to your washing machine.
• The tumble dryer must be installed in a clean place,
where dirt does not build up.
• Air must be able to circulate freely all round the appli-
ance. Do not obstruct the front ventilation grille or the
air intake grilles at the back of the appliance.
• To keep vibration and noise to a minimum when the
tumble dryer is in use, it should be placed on a firm,
level surface.
• Once in its permanent operating position, check that
the tumble dryer is absolutely level with the aid of a
spirit level. If it is not, raise or lower the feet until it is.
• The feet must never be removed. Do not restrict the
floor clearance through deep pile carpets, strips of
wood or similar. This might cause heat built-up which
would interfere with the operation of the appliance.
Important!
• The hot air emitted by the tumble dryer can reach tem-
peratures of up to 60°C. The appliance must therefore
not be installed on floors which are not resistant to
high temperatures.
• When operating the tumble dryer, the room tempera-
ture must not be lower than +5°C and higher than
+35°C, as it may affect the performance of the appli-
ance.
• Should the appliance be moved, it must be transported
vertically.
• The appliance must not be installed behind a lockable
door, a sliding door a door with a hinge on the oppo-
site side to that of the appliance in such a way that a
full opening of the tumble dryer is restricted.
Ensure min. 5cm free space around the appliance.
Removing transport safety packaging
Caution! Before use all parts of the transport
packaging must be removed.
1. Open loading door.
2. Pull off adhesive strips
from inside machine on
top of drum.
3. Remove foil hose and
polystyrene padding from
the machine.
Fitting the vent hose
To simplify the installation, there is a choice of vent out-
lets: one at the back, the others in the left and right-hand
side. Connect the hose to whichever is the more conven-
ient by pulling the ring nut (A) from the vent outlet at the
back, screwing it on to the hose and pushing it firmly back
into place. The unused vents should now be sealed with
the special snap covers provided.
A
A
If the hose is long and the
room temperature low, the
moisture might condense to
water inside the hose. This
is an unavoidable natural
phenomenon. To prevent
this water from Iying in the
hose or flowing back into
the tumble dryer, it is
advisable to drill a small hole (via. 3 mm) in the lowest
B
11
www.zanussi.com
