Zanussi ZDE, User Manual

Page: 11 / 31

use electrolux 11
Select the Start/Pause
Press this button to start the dryer after
having selected the programme and
the options.
The relevant light will stop flashing. If
the door of the appliance or the small
door at the bottom is opened while the
programme is running, this button
must be pressed again after closing
the door in order to restart the pro-
gramme from the point at which it was
interrupted. In both cases the light of
the Start/Pause button flashes to
remind you that the start button needs
to be pressed again.
IIn nd diic ca atto orr lliig gh htts s
These lights indicate the following
functions:
““D Drry yiin ng g”” lliig gh htt
This light indicates that the appliance is
in the drying phase.
““C Co oo olliin ng g”” lliig gh htt
This light indicates that the appliance is
in the cooling phase. At the end of
drying, there is a 10 minute cooling
phase to cool the laundry.
““E En nd d//A An nttiic crre ea as se e”” lliig gh htt
This light is on at the end of the cooling
phase, during the anti-creasing phase
and at the end of the programme.
Start/Pause
““F Fiilltte errs s”” lliig gh htt
It comes on every 80 cycles to remind
you that the condenser must be
cleaned.
At the end of the programme
All drying programmes end with a 10
minute cooling phase.
If the laundry is not removed at the end
of the cycle, the dryer performs an
anti-creasing phase (duration: 30 min-
utes maximum).
If you do not remove the laundry, the
dryer will stop automatically at the end
of the anti-creasing phase.
Lights end and filter remain lit and the
buzzer sounds for 2 minutes.
Turn the programme selector dial to
“Off”; all the lights go out. The appliance
is switched off.
Remove the laundry.
If you open and then close the door
before turning the selector dial to “Off” all
the indicator lights come on.
A Afftte err e ea ac ch h u us se e
• Clean the filters.
GB
125986530.qxp 2007-03-19 09:11 Page 11