TROUBLESHOOTING
Problem
Possible solution
You cannot activate the appliance.
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
The programme does not start.
Press Start/Pause.
Make sure that the appliance door is closed.
The appliance door does not close.
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
The appliance stops during operation.
Make sure that the water container is empty.
Press Start/Pause to start the programme again.
Load is too small, increase the load or use the
Time Dry programme.
The cycle time is too long or unsatisfactory dry-
ing result.
1)
Make sure that the weight of the laundry is appli-
cable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Ensure that the room temperature is higher than
+5°C and lower than +35°C. Optimal room tem-
perature is 18°C to 25°C.
Set the Time Dry or the Extra Dry programme.
2)
The tumble dryer does not heat up. The laundry
inside is cold and wet.
The filter is clogged. The emergency heater shut-
down.
Clean the filter (see chapter
CARE AND
CLEANING
).
Display shows 1 min or few minutes to the cycle
end for longer time. The laundry inside is cold
and wet.
The filter is clogged. The emergency heater shut-
down.
Clean the filter (see chapter
CARE AND
CLEANING
).
The display shows Err.
If you want to set a new programme, deactivate
and activate the appliance.
Make sure that the options are applicable to the
programme.
17
Summary of Contents for ZDC82B4PW
Page 1: ...GETTING STARTED EASY User Manual ZDC82B4PW EN User Manual Tumble Dryer ...
Page 22: ......
Page 23: ......
