This dishwasher is designed to be fitted under a
kitchen counter or sink. In either case, it is essential
that the recess dimensions indicated in the picture are
followed.
No further openings for venting of the dishwasher are
required, but only for passage of the water inlet and
drain hoses and power supply cable.
The recess height may be anywhere between 820
and 880 mm from the floor since the dishwasher in-
corporates levelling feet adjustable over a wide range
(max 60 mm).
Adjust the height of the appliance by turning these
feet.
A distance of 2 mm should be allowed between the
top of the dishwasher and the counter top.
Fitting under a counter (kitchen worktop
or sink)
It is absolutely essential that the dishwasher is dis-
connected from the electricity supply before gaining
access to any internal component.
Fit the dishwasher into the appropriate recess space
and connect it. Make sure that the water fill and drain
hoses and the power supply cable are not bent or
kinked.
Fitting the panel onto the door
The door on this model is designed for the overlay of
a panel having the following dimensions:
Width:
596 mm
Height:
644 to 714 mm max
Thickness: 20 mm max
Weight:
2 to 7.5 kg max
Warning!
The panel height should not be more than what indi-
cated, otherwise complete opening of the door will no
longer be possible as the panel hits against the dish-
washer plinth.
Mounting of decor panel onto the door
The height of the panel depends on the height of the
plinth of adjacent kitchen units (see kitchen plinth ad-
justment).
The panel must be fitted
with a handle, as the dish-
washer handle will be hid-
den by the panel.
Drill the panel with a Ø 2 x 12
bit according to the dimen-
sions indicated in the figure.
Fix the cross bar onto the panel using four 3.5x16
screws provided. Reduce the length of fixing screws
according to thickness of panel.
Reduce the length of fixing screws according to thick-
ness of panel.
Mount the decor panel by inserting the two pivots of
the cross-bar into the slotted holes of the door.
Lift the decor panel until
perfect alignment with the
facia panel is obtained.
After obtaining the best po-
sition, open the door and fix
the decor panel with the
two 4 x 40 screws provided,
using the holes through the
inner door (see fig.)
BUILDING-IN
PII07GB
30
818
÷
878
555
596
600
820
÷
880
II28
max
0
÷
60mm
II07
II19
*
*
550
30
172
596 max
II11
II10
