13
Changing the opening direction of doors
If you wish to change the opening side of the doors
proceed as follows:
1... Take off the plinth (D) pressed onto cabinet. Take
out the lid (F) and put it into the opposite hole.
2... Remove the lower hinge (E) taking care for the
lower door not to fall off. Dismantle the lower
hinge reinforcement (Z) and assemble it in the
opposite side.
3... Lift the lower door off the central hinge (H).
4... Remove the central hinge (H) taking care for the
upper door not to fall off and not to lose the plas-
tic washer.
5... Take the upper door off the upper hinge (G). Be
carefull not to lose the plastic washer.
6... Unscrew the plastic plugs located on the opposi-
te side of the central hinge and introduce them in
the holes occupied before by the hinge.
7 Unscrew the axle of the upper hing and screw it
into the hinge on the opposite side. Make sure to
fit in the metal washer for blocking.
8 Place upper door.
9... Put the central hinge (H) in the opposite side from
original position. Leave the hinge loose.
10...Place the lower door next to the lower hinge (E)
in the opposite side from original and fix all the
hinges.
11...Dismantle the vertical handles and assemble
them in the opposite side. Cover the holes with
the plastic lids that were situated where the hand-
les are presently.
12...Replace the plinth well fixed.
m
m
Once finished make sure that all joints close
perfectly well all around the door and chek that
the internal light turns of when the fridge door
closes.
How to panel the door:
If your appliance is provided with metal strips for
panelling and you wish to do so proceed as
follows:
1...Remove one of the side strips.
2...Loosen the screws of the remaining strips.
3...Start putting on the panel where you took off the
strip pushing it right up to the end.
4...Replace the strip on this side.
5...Tighten all screws
NOTE: The panel dimensions must be 2 mm. shor-
ter than the doors. Maximun thickness of the panel
is 4 mm.
F
D
F
F
F
E
E
PR18b
H
G
PR220
