35
To move the appliance, open the grill door.
Raise the appliance off its front feet by lifting
it from inside the oven. Pull the appliance
forward. When you replace the appliance
push it back to the stop and make sure there
is the same gap at each rear corner.
For your safety
Do not
try to disconnect the appliance from
the gas supply if the supply pipe does not
have a bayonet connection, as described in
the installation instructions. If this is the case
contact the person who installed the
appliance.
Location of appliance
This appliance must not be installed in a
bed-sitting room of volume less than 20m
3
or
in a bathroom, shower room or garage. It is
essential that the appliance is positioned as
Fig 1a. Shelves, wall cabinets and cooker
hoods must be fitted a minimum of 787mm
directly above the top of the hotplate (or
greater for cooker hoods if recommended by
manufacturers instructions) and 400mm
above the hotplate when fitted in line with
the outside of the appliance. If the units are
intended to be fitted adjacent to the
appliance but less than 400mm above the
hotplate, then a minimum space of 100mm
must be maintained between the sides of the
unit and the appliance (See Fig 1b).
Curtains must not be fitted immediately
behind the appliance or within 150mm of the
sides of the hotplate. If fitted next to or
between two base units a minimum space of
1mm must be left between each unit and the
sides of the appliance. The hotplate must be
set to a minimum of 7mm above the
adjacent units. (Note: The levelling feet fitted
to the appliance will achieve a nominal
height of 907mm -5+ 13mm. Base units not
meeting the above conditions must be a
minimum of 100mm away from the hotplate.
Note: - L.P.G. cookers MUST NOT be
installed below ground level i.e. in a
basement or aboard any boat, yacht or other
vessel.
Fig 1.a
Fig 1.b
